Commands Listed in Alphabetical Order
Syntax
WFMInpre:BYT_
Nr?
Related Commands
WFMInpre:BIT_Nr?
Examples
WFMINPRE:BYT_N
R?
might return WFMINPRE:BYT_ NR 4, indicating that the
byte width for waveform data is four bits.
WFMInpre:BYT_Or
Selects which byte of binary waveform data is transmitted first during a waveform
data transfer to the instrument.
Group
Waveform Transfer
Syntax
WFMInpre:BYT_Or {LSB | MSB}
WFMInpre:BYT_Or?
Related Commands
DATa:ENCdg, WFMInpre:BN_Fmt, WFMInpre:ENCdg
Arguments
LSB selects the least-significant byte to be transmitted fi rst.
MSB selects the most-significant byte to be transmitted first.
Examples
WFMINPRE:BYT_OR MSB specifies that the most-significant byte in the waveform
data will be transferred first.
WFMINPRE:BYT_OR? might return W FMINPRE:BYT_O MSB, indicating that the
most-significant byte in the waveform data will be transmitted first.
WFMInpre:ENCdg
This command sets or queries the type of encoding used for waveform data
transferred with the CURVe command.
Group
Waveform Transfer
Syntax
WFMInpre:ENCdg {ASCIi | BINary}
WFMInpre:ENCdg?
2-356 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
