Commands Listed in Alphabetical Order
Syntax
ACQuire:STOPA
fter:MODe { RUNSTop | CONDition }
ACQuire:STOPAfter:MODe?
Related Commands
ACQuire:STOPAfter:CONDition, ACQuire:STATE
Arguments
RUNSTop spe
ciļ¬es that the run and stop s tate is determined by the one of
the front-panel RUN/STOP controls.
CONDition speciļ¬es that the run and stop state of the system is determined
by a set a qualiļ¬ers speciļ¬ed by the StopAfter Condition. These sub-states
are further described in the ACQuire:STOPAfter:
CONDition section. (The
instrument can still be stopped unconditionally by pressing the front-panel
Run/Stop button or by sending the ACQuire:STATE command.)
Examples
ACQUIRE:STOPAFTER:MODE RUNSTOP sets the instrument to run or stop
acquisitions when the u ser presses the front-panel RUN/STOP button.
ACQUIRE:STOPAFTER:MODE? might return ACQUIRE:STOPAFTER:MODE
CONDITION
, indicating that the run and stop state of the system is determined by
a set of qualiļ¬ers speciļ¬ed by the StopAfter condition.
ALLEv? (Query Only)
This query only command causes the instrument to return all events and their
messages and removes the returned events from the Event Queue. The messages
are separated by commas. Use the *ESR? query to enable the events to be
returned. For a complete discussion of the u se of these registers, see the topics
in Status and Events. This command is similar to repeatedly sending *EVMsg?
queries to the instrument.
Group
Status and Error
Syntax
ALLEv?
Related Commands
*CLS, DESE, *ESE, *ESR?, EVENT?, EVMsg?, EVQty?, *SRE, *STB?
Returns
The event code and message in the following format:
<Event Code>,<QString>[<Event
Code>,<QString>]<QString>::=<Me ssage>;[<Command>]
where <Command> is the c ommand that caused the error and may be returned
when a command error is detected by the instrument. As much of the command
DSA/CSA/TDS8X00/B Series Programmer Manual 2-65
To Next Page
Loading...
Need help?
General
