Commands Listed in Alphabetical Order
RJ specifies the
right justified audio format.
TDM specifies the time-division multiplexing audio format.
Examples
BUS:B1:AUDIO:TYPE RJ sets right-justified as the audio format.
BUS:B1:AUDIO:TYPE? might return :BUS:B1:AUDIO:T YPE I2S indicating
that the audio format is set to I
2
S.
BUS:B<x>:AUDio:WORDSel:POLarity
Specifies the word select polarity for the AUDIO bus.
Conditions
This command requires the DPO4AUDIO application module for the
MDO4000/B/C series, or the MDO3AUDIO for MDO3000 series.
Group
Bus
Syntax
BUS:B<x>:AUDio:WORDSel:POLarity {NORMal|INVERTe d}
BUS:B<x>:AUDio:WORDSel:POLarity?
Arguments
NORMal specifies positive WORDSel polarity.
INVERTed specifies negative WORDSel polarity.
Examples
BUS:B1:AUDIO:WORDSEL:POLARITY NORMal sets normal as the word select
polarity.
BUS:B1:AUDIO:WORDSEl:POLARITY? might return
:BUS:B1:AUDIO:WORDSEL:POLARITY NORMAL indicating that the word select
polarity is set to normal.
BUS:B<x>:AUDio:WORDSel:SOUrce
Specifies the word select source waveform for the AUDIO bus.
Conditions
This command requires the DPO4AUDIO application module for the
MDO4000/B/C series, or the MDO3AUDIO for MDO3000 series.
Group
Bus
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-167
To Next Page
Loading...
Need help?
General
