Commands Listed in Alphabetical Order
BUS:B<x>:AUD
io:FRAMESync:SOUrce
Specifies the frame sync source waveform for the AUDIO bus.
Conditions
This command requires the DPO4AUDIO application module for the
MDO4000/B/C series, or the MDO3AUDIO for MDO3000 series.
Group
Bus
Syntax
BUS:B<x>:AUDio:FRAMESync:SOUrce {CH1|CH2|CH3|CH 4|
D0|D1|D2|D3|D4|D5|D6|D7|D8|D9|D10|D11| D12|D13|D14|D15}
BUS:B<x>:AUDio:FRAMESync:SOUrce?
Arguments
CH1–CH4 specifies an analog channel as the frame sync source waveform.
D0-D15 specifies a digital channel as the frame sync source waveform. (MSO
/MDO4000/B models only as well as MDO3000 and MDO400C models with
option MDO3MSO or MDO4MSO installed.)
Examples
BUS:B1:AUDIO:FRAMESYNC:SOURCE CH1 sets CH1 as the frame sync source.
BUS:B1:AUDIO:FRAMESYNC:SOURCE? might return
:BUS:B1:AUDIO:FRAMESYNC:SOURCE CH2 indicating that the source is set to
Ch2.
BUS:B<x>:AUDio:TYPe
Specifies the audio format (type) for the AUDIO bus.
Conditions
This command requires the DPO4AUDIO application module for the
MDO4000/B/C series, or the MDO3AUDIO for MDO3000 series.
Group
Bus
Syntax
BUS:B<x>:AUDio:TYPe {I2S|LJ|RJ|TDM}
BUS:B<x>:AUDio:TYPe?
Arguments
I2S specifies the I
2
S audio format.
LJ specifies the left-justified audio f
ormat.
2-166 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
