Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Arguments
ENET10BASET sp
ecifies the Ethernet type as 10Base-T standard. This standard
supports data transfer rates up to 10 Mbps (also called Twisted Pair Ethernet).
ENET100BASET
X
specifies the Ethernet type as 100Base-T standard. This
standard supports data transfer rates up to 100 Mbps (also called Fast Ethernet).
Examples
BUS:B1:ETHERnet:TYPe ENET100BASETX specifies the Ethernet type as
100Base-T.
BUS:B1:ETHERnet:TYPe? might return ENET10BASET, indicating that the
Ethernet type has been set to 10Base-T.
BUS:B<x>:FLEXray:BITRate
Specifies the bit rate for the FlexRay bus signal. The maximum bitrate is
100 Mbps.
Conditions
This command requires a DPO4AUTOMAX application module for 4000 series
models, and MDO3FLEX application module for MDO3000 series models.
Group
Bus
Syntax
BUS:B<x>:FLEXray:BITRate <NR1>
BUS:B<x>:FLEXray:BITRate?
Arguments
<NR1> specifies the FlexRay bus bit rate. You can enter any positive integer, and
the instrument will coerce the value to the closest supported bit rate.
Examples
BUS:B1:FLEXRAY:BITRATE 9600 sets the FlexRay bus bit rate to 9600 bits per
second.
BUS:B1:FLEXRAY:BITRATE? might return BU S:B1:FLEXRAY:BITRATE
10000000
indicating the FlexRay bit rate is 10,000,000 bits per second.
BUS:B<x>:FLEXray:CHannel
Specifies the FlexRay bus ID format.
Conditions
This command requires a DPO4AUTOMAX application module for 4000 series
models, and MDO3FLEX application module for MDO3000 series models.
2-178 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English