Commands Listed in Alphabetical Order
Group
Bus
Syntax
BUS:B<x>:POSition <NR3>
BUS:B<x>:POSition?
Argume
nts
<NR3> is a floating point number that specifies the position of the bus <x>
waveform on the display.
BUS:B<x>:RS232C:BITRate
This
command specifies the bit rate for the RS-232 bus.
Conditions
This command requires a DPO4COMP application module for 4000 series
models, and an MDO3COMP application module for MDO3000 series models.
Group
Bus
Syntax
BUS:B<x>:RS232C:BITRate <NR1>
BUS:B<x>:RS232C:BITRate?
Arguments
<NR1> is the bit rate in bits-per-second. You can enter any positive integer, and
the instrument will coerce the value to the closest supported bit rate.
BUS:B<x>:RS232C:DATABits
This command specifies the number of bits in the data frame for the RS-232 bus.
Conditions
This command requires a DPO4COMP application module for 4000 series
models, and an MDO3COMP application module for MDO3000 series models.
Group
Bus
Syntax
BUS:B<x>:RS232C:DATABits {7|8|9}
BUS:B<x>:RS232C:DATABits?
Arguments
7 specifies seven bits in the RS-232 data frame.
8 specifies eight bits in the RS-232 data frame.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-191
To Next Page
Loading...
Need help?
General
