Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Syntax
BUS:B<x>:SPI{
:CLOCk|:SCLk}:SOUrce {CH1|CH2|CH3|CH4|
D0|D1|D2|D3|D4|D5|D6|D7|D8|D9|D10|D11| D12|D13|D14|D15}
BUS:B<x>:SPI
{:CLOCk|:SCLk}:SOUrce?
Arguments
CH1–CH4 specifies an analog channel as the SCLK source waveform.
D0-D15 specifies a digital channel as the SCLK source waveform.
(MSO/MDO4000/B models only as well as MDO3000 and MDO400C models
with option MDO3MSO or MDO4MSO installed.)
BUS:B<x>:SPI:DATa{:IN|:MISO}:POLarity
This command specifies the MISO polarity for the SPI bus.
Conditions
This command requires a DPO4EMBD application module for 4000 series
models, and an MDO3EMBD application module for MDO3000 series models.
Group
Bus
Syntax
BUS:B<x>:SPI:DATa{:IN|:MISO}:POLarity {LOW|HIGH}
BUS:B<x>:SPI:DATa{:IN|:MISO}:POLarity?
Arguments
LOW specifies an active low polarity.
HIGH specifies an active high polarity.
BUS:B<x>:SPI:DATa{:IN|:MISO}:SOUrce
This command specifies the MISO source waveform for the SPI bus.
Conditions
This command requires a DPO4EMBD application module for 4000 series
models, and an MDO3EMBD application module for MDO3000 series models.
Group
Bus
Syntax
BUS:B<x>:SPI:DATa{:IN|:MISO}:SOUrce {CH1|CH2|CH3|C H4|
D0|D1|D2|D3|D4|D5|D6|D7|D8|D9|D10|D11| D12|D13|D14|D15}
BUS:B<x>:SPI:DATa{:IN|:MISO}:SOUrce?
2-196 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English