Commands Listed in Alphabetical Order
HIGH indicates
the bit rate is 480 Mbps.
Examples
BUS:B1:USB:BITRATE FULL sets the bit rate to 12 Mbps.
BUS:B1:USB:BITRATE? might return :BUS:B1:USB:BITRATE LOW,which
indicates that the bit rate is 1.5 Mbps.
BUS:B<x>:USB:PRObe
This command specifies the type of probe connected to the USB bus.
Conditions
This command requires a DPO4USB application module for 4000 series models,
and an MDO3USB application module for MDO3000 series models.
Group
Bus
Syntax
BUS:B<x>:USB:PRObe {DIFFerential|SINGleended}
BUS:B<x>:USB:PRObe?
Arguments
DIFFerential indicates the bus probe is a differential probe.
SINGleended indicates the bus probe is not a differential probe.
Examples
BUS:B1:USB:PROBE DIFFERENTIAL sets the bus probe to differential.
BUS:B1:USB:PROBE? might return :BUS:B1:USB:PROBE SINGLEENDED,
which indicates that the bus probe is not a differential probe.
BUS:B<x>:USB:SOUrce:DIFFerential
This command specifies the source waveform for the USB bus when using a
differential probe.
Conditions
This command requires a DPO4USB application module for 4000 series models,
and a
n MDO3USB application module for MDO3000 series models.
Group
Bus
2-202 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
