Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Group
Bus
Syntax
BUS:B<x>:TYPe
{I2C|SPI|CAN|RS232C|PARallel|USB|LIN|F LEXRay|AUDio|ETHERnet|
MIL1553B|ARINC429A}
BUS:B<x>:TYPe?
Arguments
I2C specifies the Inter-IC bus.
SPI specifies the Serial Peripheral Interface bus (not available on two-channel
models).
CAN specifies the Controller Area Network bus.
RS232C specifies the RS-232C bus.
PARallel specifies the Parallel bus.
USB specifies the USB bus.
LIN specifies the LIN bus.
FLEXRay specifies the FLexRay bus.
AUDio specifies the audio bus.
ETHERnet specifies the Ethernet bus.
MIL1553B specifies the MIL-STD-1553 bus.
ARINC429A specifies the Aeronautical Radio INC (specification 429) bus.
BUS:B<x>:USB:BITRate
This command specifies the bit rate for the USB bus.
Conditions
This command requires a DPO4USB application module for 4000 series models,
and an MDO3USB application module for MDO3000 series models.
Group
Bus
Syntax
BUS:B<x>:USB:BITRate {LOW|FULL|HIGH}
BUS:B<x>:USB:BITRate?
Arguments
LOW indicates the bit rate is 1.5 Mbps.
FULL indicates the bit rate is 12 Mbps.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-201

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English