Commands Listed in Alphabetical Order
(See page 2-61, Se
arch Command Group.)
Returns
<NR1> = 1 if the CAN bus feature is present.
<NR1> = 0 if the CAN bus feature is not present.
CONFIGuration:BUSWAVEFORMS:CANFD? (Query Only)
This query returns a Boolean value to indicate whether the optional CAN FD bus
triggering and analysis feature is present.
Conditions
This feature requires installation of a DPO4AUTO or DPO4AUTOMAX
application module for MDO4000C models, or MDO3AUTO for MDO3000
models.
Group
Configuration
Syntax
CONFIGuration:BUSWAVEFORMS:CANFD?
Related Commands
(See page 2-15, Bus Command Group.)
(See page 2-76, Trigger Command Group.)
(See page 2-61, Search Command Group.)
Returns
<NR1>: = 1 if the CAN FD bus feature is present.
<NR1>: = 0 if the CAN FD bus fe
ature is not present.
CONFIGuration:BUSWAVEFORMS:ETHERNET? (Query Only)
This query returns a boolean value to indicate whether the optional Ethernet
triggering and analysis feature is present. (Enabling this feature on MDO4000/B/C
and MSO/DPO4000B requires installation of a DPO4ENET application module.)
Group
Configuration
Syntax
CONFIGuration:BUSWAVEFORMS:ETHERNET?
Related Commands
(See page 2-15, Bus Command Group.)
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-245
To Next Page
Loading...
