Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
IO runs just the
IO board diagnostic group.
ROM runs just the ROM board diagnostic group.
ACQ runs just the acquisition system diagnostic group.
RF runs just the RF system diagnostic group (MDO models only).
AFG runs just the AFG system diagnostic group (models with AFG hardware).
DIAg:SELe
ct:<function> (No Query Form)
This command specifies which of the subsystems will be tested when the
DIAg:STATE EXECute command is run.
Group
Calibration and Diagnostic
Syntax
DIAg:SELect:<function>
Related Commands
DIAg:STATE EXECute
Arguments
<function> specifies a single oscilloscope subsystem on which to run self tests
(diagnostics). Valid values are:
ACQ tests the acquisition system.
APPKey tests the application keys.
CPU tests the CPU.
DISplay tests the display.
FPAnel tests the front panel controls.
IO tests the IO ports.
ROM tests the system read only memory.
Examples
DIAG:SELECT:CPU specifies that the oscilloscope will test the CPU when the
diagnostic test is run.
DIAG:STATE EXECute will actually run the test.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-287

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English