Commands Listed in Alphabetical Order
Arguments
<QString> is an
integer port number, enclosed in quotes.
NOTE. Consider the following if you are using the e*Scope™ control software. If
you don't e nter a port address in the URL, then the
ETHERnet:HTTPPort value
must be set to "80", which is the default port for HTTP protocol. If you use a URL
with a port address (for example: http://DPO4104B-04WKL4:1234), the port
number is specified by the number after the colon. Set the
ETHERnet:HTTPPort
value to thi
s same number.
Examples
ETHERNET:HTTPPORT “80” sets the HTTP port value to 80.
ETHERnet:IPADDress
This comm
and specifies the IP address assigned to the oscilloscope.
Group
Ethernet
Syntax
ETHERnet:IPADDress <QString>
ETHERnet:IPADDress?
Related Commands
ETHERnet:NETWORKCONFig,
ETHERnet:SUBNETMask,
ETHERnet:GATEWay:IPADDress
Arguments
<QString> is a standard IP address value, enclosed in quotes.
Examples
ETHERNET:IPADDRESS “123.121.13.214” sets the oscilloscope's IP address.
ETHERnet:LXI:LAN:PA SSWord:ENABle
This command controls whether LXI (LAN eXtensions for Instrumentation) is
password protected.
Group
Miscellaneous
Syntax
ETHERnet:LXI:LAN:PASSWord:ENABle {0|1|ON|OFF}
ETHERnet:LXI:LAN:PASSWord:ENABle?
2-310 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
