Tektronix MDO4000B Series - Page 526

Commands Listed in Alphabetical Order
Group
Power
Syntax
POWer:QUALity:ICRESTfactor?
Examples
POWER:QUALITY:ICRESTFACTOR? might return
:POWER:QUALITY:ICRESTfactor 1.4 indicating that the current crest factor
valueissetto1.4.
POWer:QUALity:IRMS? (Query Only)
Returns the RMS current measurement.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:QUALity:IRMS?
Examples
POWER:QUALITY:IRMS? might return :POWER:QUALITY:IRMS 1.00
indicating that the RMS current value is set to 1.00 A.
POWer:QUALity:PHASEangle? (Query O nly)
Returns the phase angle measurement.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:QUALity:PHASEangle?
Examples
POWER:QUALITY:PHASEANGLE? might return :POWER:QUALITY:PHASEANGLE
0
indicating that the phase angle is set to 0.
2-496 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual