Tektronix MDO4000B Series

Commands Listed in Alphabetical Order
Examples
POWER:SWLOSS:
CONDCALCMETHOD RDSon
sets the conduction calculation
method to RDSon.
POWER:SWLOSS
:CONDCALCMETHOD ?
might return
:POWER:SWLOSS:CONDCALCMETHOD VOLT indicating that the conduction
calculation method is set to Voltage.
POWer:SWLo
ss:CONDuction:ENERGY:MAX? (Query Only)
Returns the maximum conduction energy for switching loss calculation.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:SWLoss:CONDuction:ENERGY:MAX?
Examples
POWER:SWLOSS:CONDUCTION:ENERGY:MAX? might return
:POWER:SWLOSS:CONDUCTION:ENERGY:MAX 1 indicating that the
maximum conduction energy switching loss calculation is set to 1 J.
POWer:SWLoss:CONDuction:ENERGY:MEAN? (Query Only)
Returns the mean conduction energy in the conduction period for the switching
loss calculation.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:SWLoss:CONDuction:ENERGY:MEAN?
Examples
POWER:SWLOSS:CONDUCTION:ENERGY:MEAN? might return
:POWER:SWLOSS:CONDUCTION:ENERGY:MEAN 1 indicating that the mean
conduction energy switching loss calculation is set to 1 J.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-519