Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Examples
RF:PROBE:COMM
AND “MODE ”, “4–4V1MHz”
sets a Tektronix VPI-DPG probe
to the 4-4V1MHz mode.
RF:PROBE:COM
MAND “O UTPUT”, “ON”
turns the output of a Tektronix
VPI-DPG probe on.
RF:PROBE:C
OMMAND?“MODE”
might return RF:PROBE:COMMAND
“MODE”,“4-4V1MHZ”
.
RF:PRObe:DEGAUss (No Query Form)
This command starts a degauss/AutoZero cycle on a TekVPI current probe
attached to the RF input.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:PRObe:DEGAUss EXECute
Examples
RF:PROBE:DEGAUSS EXECute begins the degauss/AutoZero operation.
RF:PRObe:DEGAUss:STATE? (Query Only)
This command returns the state of the probe degauss for the RF input.
NOTE. This command w ill return
PASSED for probes that do not support degauss
operations.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:PRObe:DEGAUss:STATE?
Returns
NEEDED indicates the probe should be degaussed before taking measurements.
RECOMMENDED indicates the measurement accuracy might be improved by
degaussing the probe.
2-566 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English