Tektronix MDO4000B Series - Page 597

Commands Listed in Alphabetical Order
PASSED indicat
es the probe is degaussed.
FAILED indicates the degauss operation failed.
RUNNING indicates the probe degauss operation is currently in progress.
Examples
RF:PROBE:DEGAUSS:STATE? might return FAILED, indicating the degauss
operation failed.
RF:PRObe:FORCEDRange
This command specifies the range of a TekVPI probe attached to the RF input.
Conditions
MDO3
000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:PRObe:FORCEDRange <NR3>
RF:PRObe:FORCEDRange?
Arguments
<NR3> is a floating point number that specifies the range, which is probe specific.
Returns
The query form of this command returns 0.0 for probes that do not support
forced ranges.
RF:PRObe:GAIN
This command specifies the scale factor for the probe attached to the RF input.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:PRObe:GAIN <NR3>
RF:PRObe:GAIN?
Arguments
<NR3> is a floating point number that specifies the probe scale factor. Allowed
values depend on the specific probe.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-567