Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:ETHERnet:IPHeader:
PROTOcol:VALue
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:ETHERnet:IPHeader:
SOUrceaddr:VALue
Arguments
QString is a quoted string o
f up to 32 characters where the allowable characters
are 0, 1, and X. The bits specified in the quoted string replace the least significant
bits, leaving any unspecified upper bits unchanged.
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:ETHERn et:IPHeader:
DESTinationaddr:VALue “000110010010000101101000 00000001”
sets
the IP destination address to search for to 192.168.0.1.
SEARCH:SEARCH1:TRIGger:A:BUS:B1:ETHERn et:IPHeader:
DESTinationaddr:VALue
might return
"XXXXXXXXXXXXXXXXXXXXXXXXXXXXXX01".
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:MAC:ADDR:SOU:VAL
When the Ethernet search condition is set to MACADDress, this command specifies
the 48–bit MAC source address value that is to be used in the search (along with
the destination address value). The default is all X’s (don’t care).
SEARCH<x> is
the search number, which is always 1, and
B<x> is the bus number 1-4. 1-3 for the
MDO4000C and 1-2 for the MDO3000
.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER :MAC:ADDR:SOU:VAL
<QString>
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER :MAC:ADDR:SOU:VAL?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:MAC:ADDR:DEST:VAL
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-639

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English