Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIG:A:BUS:B<x>:ETHER:TCPH:SOU:VAL
When the Ethernet search condition is set to TCPHEADE R, this command specifies
the 16–bit source port address that is to be used in the search (along with the
destination
port address, the sequence number and the acknowledgement number).
The default is all X’s (don’t care).
SEARCH<x> is the search number, which is
always 1, and
B<x> is the bus number B1-B4.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Search
Syntax
SEA
RCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:TC PH:SOU:VAL
<QString>
SEA
RCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:TC PH:SOU:VAL?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:TCPHeader:
ACKnum:VALue
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:TCPH:DEST:VAL
SE
ARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:TCPHeader:
SEQnum:VALue
Arg
uments
QString is a quoted string of up to 16 characters where the allowable characters
are 0, 1, and X. The bits specified in the quoted string replace the least significant
bits, leaving any unspecified upper bits unchanged.
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:ETHERn et:TCPHeader:SOUrceport:
VALue
“XXXX000010100110” would set the source port address that is to be
used in the search to hexadecimal X0A6.
SEARCH:SEARCH1:TRIGger:A:BUS:B1:ETHERn et:TCPHeader:SOUrceport:
VALue?
might return “XXXXX01001010110”.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:CONDition
This command spec
ifies the condition to use when searching on FlexRay bus data
(start of frame, frame type, ID, cycle count, header, data, ID and data, EOF, error).
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-647

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English