Commands Listed in Alphabetical Order
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ET HERnet:QUALifier
{LESSthan|MOREthan|EQual|UNEQual|LESSE Qual|MOREEQual
|INrange|OUTrange}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ET HERnet:QUALifier?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:MAC{:LENgth|:
TYPe}:?HIVALue
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:DATa:HIVALue
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:ETHERn et:QUALifier LESSthan
sets the MACLENgth or DATa qualifier to less than.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:TCPHeader:ACKnum:VALue
When the Ethernet search condition is set to TCPHeader, this command specifies
the 32–bit acknowledgement value that is to be used in the search (along withthe
destination and source port addresses and the sequence number). The default is
all X’s (don’t care).
SEARCH<x> is the search number, which is always 1, and
B<x> is the bus number B1-B4.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ET HERnet:TCPHeader:
ACKnum:VALue <QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ET HERnet:TCPHeader:
ACKnum:VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:TCPH:DEST:VAL
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:TCPH:SOU:VAL
2-644 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
