Tektronix MDO4000B Series - Page 673

Commands Listed in Alphabetical Order
SEARCH:SEARCH
1:TRIGGER:A:BUS:B1:ETHERNET:MAC{:LENGTH|
:TYPE}:HIVALUE?
might return “XXXXXXXX00001000”.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:QTAG:VALue
When the Ethernet search condition is set to QTAG, this command specifies the
32–bit QTAG value to search for. The default is all X’s (don’t care).
SEARCH<x>
is the search number, which is always 1, and B<x> is the bus number B1-B4.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ET HERnet:QTAG:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ET HERnet:QTAG:VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
Arguments
QString is a quoted string of up to 32 characters where the allowable characters
are 0, 1, and X. The bits specified in the quoted string replace the least significant
bits, leaving any unspecified upper bits unchanged.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:ETHERN ET:QTAG:VALUE
“XXXXXXXXXXXXXXXXXXXX010010001010” would specify to search for
the Q-Tag value of hexadecimal XXXXX48A.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:ETHERN ET:QTAG:VALUE? might
return "XXXXXXXXXXXXXXXXXXXX010010001010".
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:QUALifier
This command specifies the qualifier to be used when the Ethernet search
condition is set to
MACLENgth or DATa. Normally, the Ethernet qualifier is set
to “Equal to”.
SEARCH<x> is the search number, which is always 1, and B<x> is
the bus number B1-B4.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-643