Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Arguments
LESSthan sets t
he cycle count qualifier to less than.
MOREthan sets the cycle count qualifier to greater than.
EQual sets the cycle count qualifier to equal.
UNEQual sets the cycle count qualifier to not equal.
LESSEQual sets the cycle count qualifier to less than or equal.
MOREEQual sets the cycle count qualifier to greater than or equal.
INrange sets the cycle count qualifier to in range.
OUTrange sets the cycle count qualifier to out of range.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:CYCLECOUNT:QUALIFIER
LESSthan
sets the cycle count qualifier to less than.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:CYCLECOUNT:QUALIFIER?
might return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:CYCLECOUNT:QUALIFIER
EQUAL
indicating the cycle count qualifier is set to =.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:CYCLEcount:VALue
This command specifies the low data value to be used when searching on the
FlexRay bus cycle count field. The search condition must be set to CYCLEcount
(using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:CONDition).
SEARCH<x> is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:CYCLEcount:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:CYCLEcount:
VALue?
Arguments
<QString> is a quoted string that is the cycle count binary value.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:CYCLECOUNT:VALUE
“110010”
sets the cycle count value to 110010.
2-650 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English