Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Arguments
SS specifies a se
arch based on the Slave Selection condition.
STARTofframe is applicable when BUS:B<x>:SPI:F RAMING is set to
IDLEtime. When the search condition is set to STARTofframe,theinstrument
searches on the first SPI clock after an idle time when there are no clocks.
MISO specifies a search based on the Master-In Slave-Out condition.
MOSI specifies a search based on the Master-Out Slave-In condition.
MISOMOSI specifies a search based on the Master-In Slave-Out and Master-Out
Slave-In conditions.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SPI:DATa{:MISO|:IN}:VALue
This command specifies the data in value to be used in an SPI search, if the search
condition is set to
MISO or MISOMOSI. SEARCH<x> is the search number, which
is always 1, and
B<x>
Conditions
This command requires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SP I:DATa{:MISO|:IN}:
VALue < bin>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SP I:DATa{:MISO|:IN}:
VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SPI:CONDition
Arguments
<bin> is the data string in binary format.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SPI:DATa{:MOSI|:OUT}:VALue
This command specifies the data out value to be used in an SPI search if the
search the condition is set to
MOSI,orMISOMOSI. SEA RCH<x> is the search
number, which is always 1, and
B<x>
Conditions
This command requires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-699

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English