Commands Listed in Alphabetical Order
Conditions
This command re
quires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:DATa:OFFSet <NR1>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:DATa:OFFSet?
Arguments
<NR1> is number in the range 0 to 1024.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:DA TA:OFFSET 36 sets the data
offset to 36.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:DA TA:OFFSET? might return
:SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:D ATA:OFFSET 0, indicating
thatthedataoffsetisthedefaultvalue,0.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:USB:DATa:SIZe
This command specifies the number of contiguous data bytes to search for in a
USB search. The minimum and default values are 1 and the maximum value is
16.
SEARCH<x> is the search number, which is always 1, and B<x>
Conditions
This command requires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:DATa:SIZe <NR1>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:DATa:SIZe?
Arguments
<NR1> is number in the range 1 to 16.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:DA TA:SIZE 4 sets the
oscilloscope to search on four contiguous data bytes.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:DA TA:SIZE? might return ,
:SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:D ATA:SIZE 6 indicating that
the oscilloscope will search on 6 contiguous data bytes.
2-704 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
