Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:USB:DATa:TYPe
This command specifies the data type to be used in a USB search, when the
search condition is set to
DATAPacket. SEARCH<x> is the search number, which
is always 1, a
nd
B<x>
Conditions
This command requires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:DATa:TYPe
{ANY|DATA0|DATA1}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:DATa:TYPe?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:USB:CONDition
Arguments
ANY indicates either a DATA0 or DATA1 data packet type.
DATA0 indicates a DATA0 data packet type.
DATA1 indicates a DATA1 data packet type.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:DA TA:TYPE DATA0 sets the
oscilloscope to search on a DATA0 data packet type.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:DA TA:TYPE? might return
:SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:D ATA:TYPE DATA1, indicating
that the data packet type is set to DATA1.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:USB:DATa:VALue
This command specifies the lower limit value for the inside-of-range and
outside-of-range qualifiers to be used in a USB search, when the search condition
is set to
DATAPacket. SEARCH<x> is the search number, which is always 1,
and
B<x>
Conditions
This command requires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-705

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English