Commands Listed in Alphabetical Order
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LEVel:RF_PH ASe {<NR1>|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger:A:LEVel:RF_PH ASe?
Arguments
<NR3> is a floating point number that sets the threshold level, in Volts, to use
when searching on the RF Phase vs. Time trace.
ECL sets the threshold level to a preset ECL high level of -1.3V.
TTL sets the threshold level to a preset TTL high level of 1.4V.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:FUNCtion
This command specifies the logic operator to be used in a logic search. <x> is
the search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:FUNCt ion {AND|NANd|NOR|OR}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:FUNCt ion?
Arguments
AND places a mark if all conditions are true.
NANd places a mark if any of the conditions are false.
NOR places a mark if all conditions are false.
OR places a mark if any of the conditions are true.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:CH<x>
This command specifies the logic condition to be used in a logic search w
hen the
input is an analog channel.
SEARCH<x> is the search number, which is always 1,
and
CH<x> is the channel number, which can be 1–4.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :CH<x> {HIGH|LOW|X}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :CH<x>?
2-720 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
