Commands Listed in Alphabetical Order
Arguments
HIGH specifies t
he logic high.
LOW specifies the logic low.
X specifies a "don't care" state.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:CLOCk:EDGE
This comman
d specifies the clock edge condition (rising or falling) to be used in a
logic search. <x> is the search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :CLOCk:EDGE
{FALL|RISe}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :CLOCk:EDGE?
Arguments
RISe specifies a rising edge.
FALL specifies a falling edge.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:CLOCk:SOUrce
This command specifies the clock source to be used in a logic search. <x> is the
search number, which is always 1. If a clock source is defined, then the logic
search is determined by the state of the other inputs at the clock transition. If
no clock source is defined, then the logic search is determined only by the state
of the inputs.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :CLOCk:SOUrce
{CH1|CH2|CH3|CH4|MATH|REF|NONe|D0|D1|D 2|D3|D4|D5|D6|D7|D8
|D9|D10|D11|D12|D13|D14|D15|RF_AMPlitu de|
RF_FREQuency|RF_PHASe}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :CLOCk:SOUrce?
Arguments
CH1–4 specifies an analog channel as the clock source.
MATH specifies the math waveform as the clock source.
REF specifies the reference waveform as the clock source.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-721
To Next Page
Loading...
Need help?
General
