Tektronix MDO4000B Series - Page 752

Commands Listed in Alphabetical Order
NONe specifies n
o clock source.
D0-D15 specifies a digital channel as the clock source.
RF_AMPlitude|RF_FREQuency|RF_PHASe specifyanRFtimedomaintraceas
the clock source. (MDO4000/B/C only.)
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:D<x>
This command specifies the logic condition to be used in a logic search when the
input is a digital channel.
SEARCH<x> is the search number, which is always 1,
and
D<x> is the digital channel number, which can be D0 – D16.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :D<x> {HIGH|LOW|X}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :D<x>?
Arguments
HIGH specifies a high logic level.
LOW specifies a low logic level.
X specifies a “don't care” condition.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:MATH
This command specifies the logic condition of the math input to be used in a logic
search. <x> is the search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :MATH {HIGH|LOW|X}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut :MATH?
Arguments
HIGH specifies a high logic level.
LOW specifies a low logic level.
X specifies a “don't care” condition.
2-722 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual