Commands Listed in Alphabetical Order
Conditions
This command re
quires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:FLEXray:HEADER:PAYL ength <QString>
TRIGger:A:BUS:B<x>:FLEXray:HEADER:PAYL ength?
Argum
ents
<QString> is the length of the payload portion of the Binary header string.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:HEADER:PAYLEN GTH “1100101" sets the
FlexRay header paylength to 1100101.
TRIGGER:A:BUS:B1:FLEXRAY:HEADER:PAYLEN GTH? might return
TRIGGER:A:BUS:B1:FLEXRAY:HEADER:PAYLEN GTH "XXXXXXX" indicating
the FlexRay header paylength is don't care.
TRIGger:A:BUS:B<x>:I2C:ADDRess:MODe
This command specifies the I
2
C address mode to 7 or 10-bit. B< x>
Conditions
This command requires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:I2C:ADDRess:MODe {ADDR7|ADDR10}
TRIGger:A:BUS:B<x>:I2C:ADDRess:MODe?
Arguments
ADDR7 specifies the 7-bit I
2
C address mode.
ADDR10 specifies the 10-bit I
2
C address mode.
Examples
TRIGGER:A:BUS:B1:I2C:ADDRESS:MODE ADDR10 sets the I2C address mode
to 10-bit.
2-822 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
