Commands Listed in Alphabetical Order
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:MIL1553B:TIMe:LESSL imit <NR3>
TRIGger:A:BUS:B<x>:MIL1553B:TIMe:LESSL imit?
Related Commands
TRIGger:A:BUS:B<x>:MIL1553B:CONDition
TRIGger:A:BUS:B<x>:MIL1553B:TIMe:MORELimit
Arguments
<NR3> is a floating point number that specifies either the minimum remote
terminal response time (RT) or the inter-message gap (IMG) in seconds.
Examples
TRIGger:A:BUS:B1:MIL1553B:TIMe:LESSLim it 3.0000e-6 would set
either the remote terminal response time (RT) or the inter-message gap (IMG) to
3.00 μS.
TRIGger:A:BUS:B1:MIL1553B:TIMe:LESSLim it? might return 2.0000e-6,
indicating that the RT or IMG has been set to 2.00 μS.
TRIGger:A:BUS:B<x>:MIL1553B:TIMe:MORELimit
When the MIL-STD-1553 bus trigger condition is set to TIMe, this command
specifies either the maximum remote terminal response time (RT) limit for
the amount of time the terminal has to transmit, or it specifies the maximum
inter-message gap (IMG). (You can specify the RT and IMG using the
TRIGger:A:BUS:B<x>:MIL1553B:CONDition TIMe command.)
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:MIL1553B:TIMe:MOREL imit <NR3>
TRIGger:A:BUS:B<x>:MIL1553B:TIMe:MOREL imit?
Related Commands
TRIGger:A:BUS:B<x>:MIL1553B:CONDition
TRIGger:A:BUS:B<x>:MIL1553B:TIMe:LESSLimit
2-852 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
