Installation
SPG600 & SPG300 Sync Pulse Generators Service Manual 2-5
Repackaging Instructions
When you ship this instrument, use the original packaging material if possible. If
the original packaging is unfit for use or is not available, repackage the instrument
using the following procedure:
1. Obtain a corrugated cardboard shipping carton having inside dimensions at
least six inches greater than the instrument dimensions and having a carton test
strength of at least 125 kg (275 pounds).
2. If the instrument is being shipped to a Tektronix Service Center for repair or
calibration, attach a tag to the instrument showing the following information:
The owner of the instrument (with address).
The name of a person at your company who may be contacted if additional
information is needed.
The complete instrument type and serial number.
A description of the service required.
3. Wrap the instrument with polyethylene sheeting or equivalent to protect the
outside finish and prevent entry of packing materials into the instrument.
4. Cushion the instrument on all sides by tightly packing dunnage or urethane
foam between the carton and the instrument, allowing for three inches
(7.62 cm) of padding on each side (including top and bottom).
5. Seal the carton with shipping tape or with an industrial stapler.
6. Mark the carton with the address of the Tektronix Service Center and your
return address in one or more prominent locations.
Installed Options
Your instrument may be equipped with one or more instrument options. Except for
the line-cord options described by Table 2-2 on page 2-3, all options are listed and
described in Section 7, Options. For further information and prices of instrument
options, see your Tektronix Products catalog or contact your Tektronix Field
Office.
To Next Page
Loading...
Need help?
General
