Menus
3-24 SPG600 & SPG300 Sync Pulse Generators User Manual
PAL Burst. Burst locks to a PAL black burst signal applied to the REF connector.
CW 1, 3.58, 4.43, 5, and 10 MHz. Locks to 1, 3.58, 4.43, 5, and 10 MHz continuous
wave signals applied to the REF connector respectively.
Press the ENTER button to confirm the selection.
GENLOCK TIMING
Adjusts the timing offset of the input signal relative to the internal reference signal
(frame reset signal). When you select this menu item and then press the ENTER
button, you will access the Genlock timing submenu. Refer to Genlock Timing
Submenu on page 3-25 for detailed information.
LOCK LOSS ACTION
Sets the way the sync pulse generator will react when a loss of genlock state occurs
(for example, genlock source is absent or incompatible). The selections are:
Internal Mode. When a loss of genlock state occurs, the instrument automatically
switches to the internal reference, and the EXT.REF indicator blinks.
Stay Mode. When a loss of genlock state occurs, the instrument maintains the
current state.
Press the ENTER button to confirm the selection.
To Next Page
Loading...
Need help?
General
