EasyManuals Logo
Home>Tektronix>Test Equipment>TBS1000 Series

Tektronix TBS1000 Series Installation And Safety Manual

Tektronix TBS1000 Series
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Compliance Information
Safety Compli
ance
EC Declaration of
Conformity Low Voltage
Compliance was demonstrated to the following specication as listed in the
Ofcial Journal of the European Communities:
Low Voltage Directive 2006/95/EC.
EN 61010-1: 2001. Safety requirements for electrical equipment for
measurement control and laboratory use.
U.S. Natio
nally Recognized
Testing Laboratory Listing
UL 61010-1:2004, 2
nd
Edition. Standard for electrical measuring and test
equipment.
Canadian Certication
CAN/CSA-C22.2 No. 61010-1:2004. Safety requirements for electrical
equipment for measurement, control, and laboratory use. Part 1.
Additional Complian ces
IEC 61010-1: 2001. Safety requirements for electrical equipment for
measurement, control, and laboratory use.
Equipment Type
Test a
nd measuring equipment.
Safety Class
Class1–groundedproduct.
Pollution Degree
Description
A measure of the contaminants that could occur in the environment around
and within a product. Typically the internal environment inside a product is
considered to be the same as the external. Products s hould be used only in the
environment for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in t his category are generally encapsulated, hermetically sealed, or
lo
cated in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
O
ccasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical ofce/home environment. Temporary
condensation occurs only when the product is out of service.
Pollution Degree 3. Conductive pollution, or dry, nonconductive pollution
that becomes conductive due to condensation. These are sheltered locations
where neither temperature nor humidity is controlled. The area is protected
from direct sunshine, rain, or direct wind.
Pollution Degree 4. Pollution that generates persistent conductivity through
conductive dust, rain, or snow. Typical outdoor locations.
TBS1000 Series Oscilloscopes Installation and Safety Manual 5

Table of Contents

Other manuals for Tektronix TBS1000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TBS1000 Series and is the answer not in the manual?

Tektronix TBS1000 Series Specifications

General IconGeneral
BrandTektronix
ModelTBS1000 Series
CategoryTest Equipment
LanguageEnglish

Related product manuals