Compliance Information
Installation (Ov ervoltage)
Category Descriptions
Terminals on th
is product may have different installation (overvoltage) category
designations. The installation categories a re:
Measurement C
ategory IV. For measurements performed at the source of
low-voltage installation.
Measuremen
t Category III. For measurements performed in the building
installation.
Measuremen
t Category II. For measurements performed on circuits directly
connected to the low-voltage installation.
Measureme
nt Category I. For measurements performed on circuits not
directly connected to MAINS.
Overvoltage Category
Overvoltage Category II (as defined in IEC 61010-1).
Environmental Considerations
This section provides information about the environmental impact of the product.
Product End-of-Life
Handling
Observ
e the following guidelines when recycling an instrument or component:
Equipment Recycling. Production of this equipment required the extraction and
use of natural resources. The equipment may contain substances that could be
harmful to the environment or human health if improperly handled at the product’s
end of life. In order to avoid release of such substances into the environment and
to re
duce the use of natural resources, we encourage you to recycle this product
in an appropriate system that will ensure that most of the materials are reused or
recycled appropriately.
This symbol indicates that this product complies with the applicable European
Un
ion requirements according to Directives 2002/96/EC and 2006/66/EC
on waste electrical and electronic equipment (WEEE) and batteries. For
information about recycling options, check the Support/Service section of the
Te
ktronix Web site (www.tektronix.com ).
Restriction of Hazardous
Substances
T
hisproductisclassified as an industrial monitoring and c ontrol instrument,
and is not required to comply with the substance restrictions of the recast RoHS
Directive 2011/65/EU until July 22, 2017.
6 TBS1000 Series Oscilloscopes Installation and Safety Manual