Tektronix TDS1002

Index
TDS200/1000/2000 Series Oscilloscope Programmer Manual
Index−3
CURSOR:VBARS?, 2-62
CURSOR:VBARS:DELTA?, 2-62
CURSOR:VBARS:POSITION<x>,
2-63
CURSOR:VBARS:UNITS, 2-64
CURVE, 2-65
D
DATA, 2-67
DATA:DESTINATION, 2-68
DATA:ENCDG, 2-68
DATA:SOURCE, 2-70
DATA:START, 2-71
DATA:STOP, 2-72
DATA:TARGET, 2-73
DATA:WIDTH, 2-73
DCL, 2-5, 3-7
*DDT, 2-74
DESE command, 2-75, 3-5
DESER register, 2-75, 2-122, 3-4
Device clear, 2-5
DIAG:RESULT:FLAG?, 2-76
DIAG:RESULT:LOG?, 2-77
Display command group, 2-17
Display commands
DISPLAY?, 2-77
DISPLAY:CONTRAST, 2-78
DISPLAY:FORMAT, 2-78
DISPLAY:INVERT, 2-79
DISPLAY:PERSISTENCE, 2-80
DISPLAY:STYLE, 2-81
DISPLAY?, 2-77
DISPLAY:CONTRAST, 2-78
DISPLAY:FORMAT, 2-78
DISPLAY:INVERT, 2-79
DISPLAY:PERSISTENCE, 2-80
DISPLAY:STYLE, 2-81
E
Entering commands, 2-5
Entering incorrect numeric argu-
ments, 2-10
EOM (end of message), 2-8
Error message, programming
interface, 3-17
ERRORLOG:FIRST?, 2-81
ERRORLOG:NEXT?, 2-82
*ESE, 2-82, 3-5
ESER register, 2-82, 2-122, 3-5
*ESR?, 2-84
*ESR? query, 3-2
Event handling, 3-1
Event query, 2-84, 2-85
Event queue, 2-84, 2-85, 3-7
Event queue sequence, 3-8
EVENT?, 2-84
EVMSG?, 2-85
EVQTY?, 2-86
Examples
block argument, 2-13
Programming, 4-1
quoted strings, 2-12
F
FACTORY, 2-86
Factory setup, detailed description,
B-3
G
GPIB, EOM (end of message), 2-8