Tektronix TDS1002 Programmer's Manual

Command Descriptions
2−38
TDS200/1000/2000 Series Oscilloscope Programmer Manual
H TDS1000 and TDS2000 series: if the Trigger mode is set to Auto,
and the Horizontal Scale is 10 ms/div or slower, changing the
vertical position does not reset the value
NOTE . In Scan mode, ACQuire:NUMACq? always returns zero.
Acquisition
ACQuire:NUMACq?
<NR1>
ACQuire:NUMACq?
might return 350, indicating that 350 acquisitions took place since an
ACQuire:STATE RUN command was executed.
ACQuire:NUMAVg
Sets the number of oscilloscope waveform acquisitions that make up
an averaged waveform. This command is equivalent to setting the
Averages option in the Acquire menu.
Acquisition
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
Group
Syntax
Returns
Examples
Group
Syntax

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz