Command Descriptions
2-76
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
CURSor:HBArs:POSITION<x>
Sets or queries the position of the specified horizontal bar cursor relative to
ground.
Cursor
CURSor:HBArs:POSITION<x> <NR3>
CURSor:HBArs:POSITION<x>?
<x> specifies the cursor. Valid values are 1 and 2.
<NR3> specifies the cursor position relative to ground, typically in volts.
CURSOR:HBARS:POSITION1 2.0E+1
positions horizontal cursor 2 at 20.0 units, typically volts, relative to ground.
CURSOR:HBARS:POSITION2?
might return :CURSOR:HBARS:POSITION2 0.0E0, indicating that one of the
horizontal bar cursors is at 0.0 units, typically volts, relative to ground.
CURSor:HBArs:SELect
Sets or returns which horizontal bar cursor is active for front-panel control. The
active cursor will be displayed as a solid horizontal line and can be moved using
the front-panel general purpose knob when cursors are displayed. The unselected
cursor will be displayed as a dashed horizontal line. This command is equivalent
to pressing the SELECT button on the front panel when cursors are displayed.
Cursor
CURSor:HBArs:SELect { CURSOR1 | CURSOR2 }
CURSor:HBArs:SELect?
CURSOR1 selects the first horizontal bar cursor.
CURSOR2 selects the second horizontal bar cursor.
Group
Syntax
Arguments
Examples
Group
Syntax
Arguments
To Next Page
Loading...
