Tektronix TDS3000 Series Program Manual

Getting Started
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
1-3
Your program may request information from the oscilloscope. The oscilloscope
provides information in the form of status and error messages. Figure 1--3 on
page 1--3 illustrates the basic operation of this system.
The Status and Events chapter starting on page 3--1 describes how to use service
requests (SRQs) and various event messages in your programs.
Your program requests
status and event reports
as the Controller.
The oscilloscope sends status and
event reports using a communications
module or the Ethernet port built--in on
TDS3000B/TDS3000C series models.
GPIB Cable
Figure 1- 3: Service Requests (SRQs) provide f or event (interrupt) driven programs
Status and Events

Tektronix TDS3000 Series Specifications

General

Brand	Tektronix
Model	TDS3000 Series
Category	Test Equipment
Language	English