Getting Started
1-6
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
Installing a Communication Module
CAUTION. To avoid damage to the oscilloscope or communication module,
observe all ESD precautions described in the User manual.
NOTE. Do not install a TDS3EM module into a TDS3000B Series or TDS3000C
Series oscilloscope. Installing the TDS3EM module will cause both the built-in
Ethernet port and the module’s Ethernet port to stop functioning.
To install one of the optional communication modules, follow these steps:
1. Turn the oscilloscope power off.
2. Push down on the latching tab to remove the blank cover.
3. Slide the communication module into the compartment until the internal
connectors are seated and the latching tab locks.
4. Turn power on. The communication module is now ready for your use.
To remove a communication module, follow these steps:
1. Turn the oscilloscope power off.
2. Push down on the latching tab and then use a small screwdriver to alternately
pry out the sides of the communication module.
3. Slide out the communication module and store it in an ESD-shielded bag
Install the blank cover if no other communication module is to be installed.
Latching tab
Figure 1- 6: Communication module mounting location
To Next Page
Loading...
Need help?
General
