Tektronix TDS3000 Series - Table 2- 5: Alias Commands

Command Groups
2-12
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
Table 2- 4: Acquisition commands (cont.)
Header Description
WAVEAlert:STATE
(TDS3000B and TDS3000C Series)
Sets or returns the WaveAlert testing mode
WAVEAlert:STOPOnviolation
(TDS3000B and TDS3000C Series)
Sets or returns the Stop on Violat ion mode
WAVEAlert:TYPe
(TDS3000B and TDS3000C Series)
Sets or returns the WaveAlert Highlight
Anomaly mode
Alias Commands
Alias commands let you define your own commands as a sequence of standard
commands. This is useful when you use the same commands each time you
perform a certain task, such as setting up measurements. Table 2--5 lists these
commands.
Table 2- 5: Alias commands
Header Description
ALIas Turn the alias state on and off
ALIas:CATALOG? Return a list of aliases
ALIas:DEFINE Create a new alias
ALIas:DELEte Remove an alias
ALIas:DELEte:ALL Remove all aliases
ALIas:DELEte:NAME Remove a named alias
ALIas:STATE Turn the alias state on and off