Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-117
ETHERnet:DCHPBOOTP
(TDS3000B Series, TDS3000C Series, and TDS3EM Only)
Sets or returns the network initialization search for a DCHP/BOOTP server.
Ethernet
ETHERnet:DCHPBOOTP { OFF | ON | <nr1> }
ETHERnet:DCHPBOOTP?
ON or nr1 ≥ 1 enables the oscilloscope to search the network for a DCHP or
BOOTP server in order to automatically assign a dynamic IP address to the
oscilloscope.
NOTE. Do not use DCHP/BOOTP searching if your oscilloscope has been
assigned a static address on a network. If you set this command to ON, the
DCHP/BOOTP search will delete or change your static IP address information.
OFF or nr1 ≤ 0 disables the oscilloscope to search the network for a DCHP or
BOOTP server.
ETHERNET:DCHPBOOTP ON
sets the oscilloscope to search for a DCHP or BOOTP server and assign a
dynamic IP address to the oscilloscope.
ETHERnet:DNS:IPADDress
(TDS3000B Series, TDS3000C Series, and TDS3EM Only)
Sets or returns the network Domain Name Server (DNS) IP address.
Ethernet
ETHERnet:DNS:IPADDress <QString>
ETHERnet:DNS:IPADDress?
<QString> is a standard IP address value, enclosed in quotes.
Group
Syntax
Arguments
Example
Group
Syntax
Arguments
To Next Page
Loading...
Need help?
General
