Tektronix TDS3000 Series - Page 183

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 145
HORizontal:DELay:STATE { ON | OFF }
HORizontal:DELay:STATE?
ON or <NR1> ¸ 0 sets the delay on so that the acquisition is positioned relative to
the delay time.
OFF or <NR1> = 0 sets the delay off so that the acquisition is positioned relative
to the trigger position.
HORIZONTAL:DELAY:STATE ON
sets the delay state to on.
HORizontal:DELay:TIMe
Sets or returns the delay time between the trigger and the center of the screen.
The delay time begins at the trigger location; the acquisition is centered at the
end of the delay time.
Horizontal
HORizontal:DELay:TIMe <NR3>
HORizontal:DELay:TIMe?
<NR3> is the time, in seconds, between the trigger and the center of the screen. It
can vary from 100% pretrigger (which means the trigger point is off screen to the
right), measured in seconds, to about 50 s (depending on time base setting) post
trigger (which means the trigger point is off screen to the left). Delay time is
positive when the trigger is located to the left of the center screen.
HORIZONTAL:DELAY:TIME 2.0E-3
sets the delay time between the trigger and the center of the screen to 2 ms.
HORizontal:DELay:STATE
Syntax
Arguments
Examples
Group
Syntax
Arguments
Examples
Related Commands