Command Descriptions
2- 194
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
MASK:USER:MASK<m>:POINTS
(Requires TDS3TMT)
Sets or returns the X-Y user coordinates of all points in the specified User mask
segment. The set form defines new points in the User mask, replacing any
existing points in the specified User mask segment.
Mask
MASK:USER:MASK<m>:POINTS <NR3>, <NR3> [, <NR3>, <NR3> ]
MASK:USER:MASK<m>:POINTS?
<m> is an integer that specifies the User mask segment number.
NR3 refers to the coordinates of one of the vertices in the User mask. Each pair of
numbers is the horizontal and vertical coordinates of a mask segment vertex. The
pairs must be listed in a counterclockwise order. If the vertical or horizontal scale
or position is changed after this command and then the query form of this
command is issued, then the value returned from the oscilloscope will not be the
same. If just one pair is input then they are ignored and the User mask segment is
marked as undefined. The default is no points in the User mask segment.
MASK:USER:MASK2:POINTS -2.3e-9, 44e-3, -2.5e-9, 47e-3,
1.2e-9, 40e-3
defines the points in User mask segment 2.
MASK:USER:MASK<m>:POINTSNorm
(Requires TDS3TMT)
The set form of this command only affects the User mask, regardless of the
current mask standard. Any currently existing points in the specified User mask
segment are deleted.
Mask
MASK:USER:MASK<m>:POINTSNorm <NR3>, <NR3> [, <NR3>, <NR3> ]
MASK:USER:MASK<m>:POINTSNorm?
Group
Syntax
Arguments
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
