Tektronix TDS3000 Series - Page 257

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 219
MEASUrement:MEAS<x>:DELay:EDGE1 { FALL | RISe }
MEASUrement:MEAS<x>:DELay:EDGE1?
FALL specifies the falling edge.
RISe specifies the rising edge.
MEASUREMENT:MEAS3:DELAY:EDGE1 RISE
specifies that the rising edge be used for measurement 3.
MEASUREMENT:MEAS1:DELAY:EDGE1?
returns either RISE or FALL for measurement 1.
MEASUrement:MEAS<x>:DELay:EDGE2
Sets or returns the slope of the edge that is used for the delay “to” waveform
when taking a delay measurement. The waveform is specified by
MEASUrement:MEAS<x>:SOURCE2. This command is equivalent to selecting
the edges in the MEASURE > Delay side menu.
Measurement
MEASUrement:MEAS<x>:DELay:EDGE2 { FALL | RISe }
MEASUrement:MEAS<x>:DELay:EDGE2?
FALL specifies the falling edge.
RISe specifies the rising edge.
MEASUREMENT:MEAS2:DELAY:EDGE2 RISE
specifies that the rising edge be used for the second delay measurement.
MEASUREMENT:MEAS2:DELAY:EDGE2?
might return FALL showing that the falling or negative edge of the waveform is
used for the second measurement.
Syntax
Arguments
Examples
Group
Syntax
Arguments
Examples