Tektronix TDS3000 Series - Page 270

Command Descriptions
2- 232
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
MEASUREMENT:REFLEVEL:PERCENT:MID2 40
specifies that the mid reference level is set to 40% of HIGH.
MEASUrement:SNAPShot (Set Only)
Displays the measurement snapshot list on the oscilloscope screen, which is a list
of the immediate values of all available measurements for the active signal.
Measurement
MEASUrement:SNAPShot
MEASUREMENT:SNAPSHOT
MEASUrement:STATIstics:MODE
(Requires TDSAAM)
Controls the operation and display of measurement statistics.
Measurement
MEASUrement:STATIstics:MODE { OFF | MINMax | MEANSTDdev }
MEASUrement:STATIstics:MODE?
OFF turns measurements off. This is the default value.
MINMax turns on statistics and displays the min and max statistics.
MEANSTDdev turns on statistics and displays the mean and standard deviation
statistics.
MEASUREMENT:STATISTICS:MODE MINMAX
turns on statistics and displays the min and max statistics.
Examples
Group
Syntax
Examples
Group
Syntax
Arguments
Examples