Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 241
PASSWord (No Query Form)
Enables the *PUD and NEWpass set commands. Sending PASSWord without
any arguments disables these same commands. Once the password is successful-
ly entered, the *PUD and NEWpass commands are enabled until the oscilloscope
is powered off, or until the FACtory command, the PASSWord command with
no arguments, or the *RST command is issued.
To change the password, you must first enter the valid password with the
PA SSWord command and then change to your new password with the NEWpass
command. Remember that the password is case sensitive.
Miscellaneous
PASSWord
PASSWord <QString>
<QString> is the password and can include up to 10 characters. The factory
default password is “XYZZY”and is always valid.
PASSWORD ”XYZZY”
Enables the *PUD and NEWpass set commands.
PASSWORD
Disables the *PUD and NEWpass set commands. You can still use the query
version of *PUD.
NEWpass, *PUD
Group
Syntax
Arguments
Examples
Related Commands
To Next Page
Loading...
Need help?
General
