Command Descriptions
2- 260
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
SELect:CONTROl
Sets or queries the waveform that is currently affected by the cursor and vertical
commands.
Vertical
SELect:CONTROl <wfm>
SELect:CONTROl?
<wfm> is CH<x>, MATH<x>, or REF<x>, and will be the selected waveform.
NONE if all waveforms are of f. NONE is ignored on input.
CH<x>, MATH<x>, or REF<x> if it is the waveform affected by the cursor and
vertical commands.
SELECT:CONTROL?
might return :SELECT:CONTROL MATH1 indicating MATH1 is the selected wave-
form.
SELect:<wfm>
Turns the specified waveform ON or OFF. Turning a waveform ON makes it the
selected waveform.
Vertical
SELect:<wfm> { OFF | ON }
SELect:<wfm>?
<wfm> specifies the waveform to display. Valid values are CH1, CH2, CH3, CH4,
MATH, MATH1 (same as MATH), REF1, REF2, REF3,andREF4.
OFF or 0 turns off the display of the specified waveform.
ON or 1 turns on the display of the specified waveform. The waveform also
becomes the selected waveform.
Group
Syntax
Arguments
Returns
Examples
Group
Syntax
Arguments
To Next Page
Loading...
