Tektronix TDS3000 Series - Page 3

TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
i
Table of Contents
Preface
Related Manuals vii.................................................
Getting Started
Overview of the Manual 1--2...........................................
Communication Modules 1--4..........................................
Installing a Communication Module 1--6.................................
Connector Locations 1--7..............................................
Setting Up Ethernet Remote Communications 1--8.........................
Setting Up GPIB Remote Communications 1--18............................
Setting Up RS-232 Remote Communications 1--21..........................
Comparing GPIB and RS-232 1--26......................................
Command Syntax and Commands
Command and Query Structure 2--1.....................................
Clearing the Oscilloscope Output Queue 2--4..............................
Command Entry 2--4.................................................
Constructed Mnemonics 2--7...........................................
Argument Types 2 --8.................................................
Command Groups 2--11.........................................
Acquisition Commands 2--11...........................................
Alias Commands 2--12.................................................
Calibration and Diagnostic Commands 2--13...............................
Cursor Commands 2--14...............................................
Display Commands 2--16...............................................
Ethernet Commands 2--17..............................................
File System Commands 2--18...........................................
Front Panel Commands 2--18...........................................
Hard Copy Commands 2--19............................................
Horizontal Commands 2--19............................................
ITU601 Digital Video Commands (TDS3SDI Only) 2--20.....................
Limit Test Commands (Requires TDS3LIM) 2--21..........................
Mask Commands (TDS3000B Series and TDS3000C Series
with TDS3TMT) 2--22.............................................
Math Commands 2--27.................................................
Measurement Commands 2--28..........................................
Miscellaneous Commands 2--30.........................................
RS-232 Commands 2--32...............................................
Save and Recall Commands 2--32........................................
Status and Error Commands 2--33........................................
Trigger Commands 2--34...............................................
Vertical Commands 2--38..............................................
Waveform Commands 2--39............................................
Command Descriptions 2--45.....................................