Tektronix TDS3000 Series - Page 349

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 311
ON or <NR1> ¸ 0 turns on the hardcopy operation for the waveform when a new
waveform is significantly different.
OFF or <NR1> = 0 turns off the hardcopy operation.
WAVEALERT:HARDCOPY ON
specifies that the hardcopy operation occurs when a new waveform data varies
significantly from previous waveforms.
WAVEALERT:HARDCOPY?
returns either 0 or 1, indicating whether the hardcopy operation occurs when a
new waveform data varies significantly from previous waveforms.
WAVEAlert:SAVEWFM
(TDS3000B Series and TDS300C Series)
Sets or returns saving WaveAlert anomaly waveforms to file.
Acquisition
WAVEAlert:SAVEWFM { OFF | ON | <NR1> }
WAVEAlert:SAVEWFM?
OFF or <NR1> = 0 disables saving anomaly waveforms to a file.
ON or <NR1> ¸ 0 enables saving anomaly waveforms to a file.
WAVEALERT:SAVEWFM ON
specifies that the oscilloscope save an anomaly waveform to the disk or flash
drive.
Arguments
Examples
Group
Syntax
Arguments
Examples