Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 313
WAVEAlert:STOPOnviolation
(TDS3000B Series and TDS3000C Series)
Sets or returns the WaveAlert stop on violation setting. When enabled, this
command stops waveform acquisitions on the first occurance of a WaveAlert
waveform anomaly.
Acquisition
WAVEAlert:STOPOnviolation { OFF | ON }
WAVEAlert:STOPOnviolation?
OFF or 0 turns off the stop on violation mode.
ON or 1 turns on the stop on violation mode.
WAVEALERT:STOPONVIOLATION?
returns either 0 or 1, indicating whether stop on violation is off or on.
WAVEAlert:TYPe
(TDS3000B Series and TDS3000C Series)
Sets or returns the WaveAlert anomaly waveform highlight type.
Acquisition
WAVEAlert:TYPe { ENTire | ANOMaly }
WAVEAlert:TYPe?
ENTire sets the oscilloscope to highlight the entire anomalous waveform.
ANOMaly sets the oscilloscope to highlight just that portion of the anomalous
waveform that is different than the base waveform.
WAVEALERT:TYPE?
might return WAVEAlert:TYPe ENTire, indicating that the entire anomaly
waveform is highlighted.
Group
Syntax
Arguments
Examples
Group
Syntax
Arguments
Examples
To Next Page
Loading...
Need help?
General
