EasyManuals Logo

Tektronix TDS3000 Series Program Manual

Tektronix TDS3000 Series
418 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #354 background imageLoading...
Page #354 background image
Command Descriptions
2- 316
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
WFMPre:B YT_Nr
Sets or queries the data width for the waveform to be transferred. This command
is equivalent to DATa:WIDth. Changing WFMPre:BYT_Nr also changes
WFMPre:BIT_Nr and DATa:WIDth.
Waveform
WFMPre:BYT_Nr <NR1>
WFMPre:BYT_Nr?
<NR1> is an integer in the range of 1 to 2 that sets the number of bytes per point.
WFMPRE:BYT_NR 2
specifies that there are 2 bytes per waveform data point.
DATa:WIDth, WFMPre:BIT_Nr
WFMPre:B YT_Or
Sets or queries which byte of binary waveform data is transmitted first during a
waveform data transfer when DATa:WIDth or WFMPre:BYT_Nr is set to 2, or
WFMPre:BIT_Nr is set to 16. Changing WFMPre:BYT_Or changes
DATa:ENCdg (if DATa:ENCdg is not ASCIi). This specification only has
meaningwhenWFMPre:ENCdgisBIN.
Waveform
WFMPre:BYT_Or { LSB | MSB }
WFMPre:BYT_Or?
LSB selects the least significant byte to be transmitted first.
MSB selects the most significant bye to be transmitted first.
Group
Syntax
Arguments
Examples
Related Commands
Group
Syntax
Arguments

Table of Contents

Other manuals for Tektronix TDS3000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TDS3000 Series and is the answer not in the manual?

Tektronix TDS3000 Series Specifications

General IconGeneral
BrandTektronix
ModelTDS3000 Series
CategoryTest Equipment
LanguageEnglish

Related product manuals